Fisher & PaykelRepair Miami

Symptom

Fisher & Paykel DishDrawer will not drain

A drawer that finishes — or stops and beeps — with water still in it. The maker publishes a code for this and publishes the causes with it, and both of them are things you can look at yourself before anybody is called.

  • From $95 diagnostic, credited to the repair
  • 59 cities and neighborhoods covered
  • OEM parts available on order
  • In writing the price, before anything is opened

Five ordinary causes

What this usually turns out to be

Cheapest and commonest first, which is also the order we check them in. They sit hundreds of dollars apart, and only the unit settles which one is yours.

In five minutes

Before you call anybody

None of it needs tools, and all of it makes the visit shorter.

  1. 01

    Note the lights before you clear anything

    On a DishDrawer the code is a pattern. If only the wash modifier lights are flashing it is an A condition; if the lock light is flashing with them it is an F. That distinction is worth more than anything else you can write down.

  2. 02

    Scoop the water out

    A cup and a towel. It makes everything below possible and it stops the drawer smelling by tomorrow.

  3. 03

    Filter and filter plate, both

    Out, rinsed, and back in seated squarely. Look at what came off them — that is what has been slowing the drain.

  4. 04

    Follow the hose to the sink

    Behind the machine for a kink, then under the sink to where it connects. If a disposal went in at the same time as the dishwasher, check its plug came out.

  5. 05

    Then book the visit

    Tell us the model number, which drawer on a double, and whether the front is your own cabinet panel — that last one decides how long the appointment runs.

How it shows up

What people describe when they call

  • “Water above the filter at the end of a cycle”
  • “The drawer beeps and the modifier lights flash”
  • “It drains if you run it again”
A tall run of pale oak cabinet doors in a bright kitchen where two of the doors are in fact appliance fronts, identifiable only by the thin shadow gap and a recessed finger pull.

A shortcut

Narrow it down before anybody arrives

A description of the behaviour leaves a few possible causes. A code names the subsystem before anybody opens anything, which is why it is worth photographing before it clears.

If the display is showing something

Photograph it before it clears — codes do not wait. Search the full code list

In more detail

About Fisher & Paykel DishDrawer will not drain

The fastest diagnosis is the code

Take the filter out. On a DishDrawer it lifts from the floor of the drawer, and the flat filter plate underneath comes out with it — a filter that looks clean on top is very often packed underneath. Rinse both under a tap and put them back seated properly. Then check the drain hose where it reaches the sink trap, waste tee or standpipe. Those two are the maker's own published causes for A3, in its own order.

Five things the water goes through, and one of them is a part

Out of the drawer through a filter and a filter plate, into a pump, along a hose, and into a sink trap, waste tee or standpipe. Every one of those can stop it, four of them cost nothing to check, and two are not inside the appliance at all. That is why this is the symptom most worth ten minutes of your own time on the whole site.

What the maker says about A3

Its published causes are the filter clogged or seated incorrectly, and the drain hose blocked or kinked at its connection. Its published remedy is to fix those, then press once to stop the beeping, press again to clear the code, and press to resume the program. That is the maker's own instruction, in its own order, and it is where we start too.

A paneled front changes the appointment, not the diagnosis

Twenty-two of this maker's fifty-one dishwashing machines are integrated, which means the front is your own cabinetry hung on the appliance. Nothing about the diagnosis changes. What changes is that the panel comes off before the machine comes out and goes back on aligned afterwards. Say so when you book and the time is planned rather than found.

This article is based on:

  • Official manufacturer documentation
  • Internal repair procedures
  • Technician repair history
  • Company quality standards

Before you book

Questions about fisher & Paykel DishDrawer will not drain

It drains if I run it a second time.

That is a partial blockage rather than a stopped pump, and it is the cheapest version of this problem. Something is slowing the water enough that the drawer times out on the first attempt and gets there on the second. The filter is the first suspect, the hose the second.

Is a little water in the bottom normal?

A small amount in the very bottom of the sump is normal and is meant to be there — it keeps seals from drying out. Water covering the floor of the drawer, or standing above the filter, is not.

One drawer drains and the other does not.

That is entirely possible and it is useful information. Each drawer has its own filter, its own pump and its own drain path, so a blockage on one side says nothing about the other. Keep using the working drawer while the other one waits.

Tell us the model number and what it is doing.

Call (305) 902-4477