Repair cost
Fisher & Paykel dishwasher control & motor repair cost
The highest dishwashing row, and the one where we are most likely to advise against the repair. A double DishDrawer carries two wash controllers and two motor controllers, and that is the reason the figure sits where it does.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
The short version
Where this figure comes from
A starting point for built-in appliances in South Florida, published so the number is not a mystery until somebody is standing in your kitchen.
Starts at
from $265
After a diagnostic from $95, which comes off the bill when you go ahead with the work.
or call (305) 902-4477
It is not
A quote for your unit
Exact cost
Confirmed after the on-site diagnostic
Warranty
On the labor we performed
What moves it
Why two of the same job cost different amounts
These apply at the same time and in both directions. Which of them is true of your kitchen is what the on-site diagnostic settles.
-
Which board
A wash controller and a motor controller are different parts with different figures, and the code alone does not separate them — the motor has to be tested under load.
-
One drawer or both
The single largest variable. Two failed controllers on an older machine is the case where replacement usually wins, and you get that arithmetic before anything is ordered.
-
Whether it is actually a board
Two of the ten published F conditions are not: flood or foaming, which clears overnight without detergent, and the rotor, which clears by hand. Both are excluded first.
-
Access
Whether the machine leaves its opening, and whether a cabinet panel comes off with it.
The work itself
What we actually do
The job behind the figure: what it involves, when a symptom points at it, and what we check first.
-
from $265 Dishwasher control & motor repair
The end of the list rather than the beginning: a wash controller, a motor controller, a rotor or a communication error between two drawers. On this maker these are the conditions that report as an F — a flashing pattern on a drawer, an F30 to F90 on a drop-door — and the maker says outright that most of them need somebody.
- F conditions read properly before a board is quoted
- Rotor and lid motor checked before either controller
- On a double, which controller — they are separate
In more detail
About Fisher & Paykel dishwasher control & motor repair cost
Why this is the top of the dishwashing rows
Because the parts are electronic assemblies rather than mechanical components, and because a double DishDrawer has two of each. It is also the row where the honest answer is most often "not worth it" — and you get that answer before an order is placed rather than after.
What is excluded before we get here
F1, flood or excess foaming, which the maker's own instruction clears with a night off and a cycle without detergent. F2, the rotor, which is debris rather than a part. And the three free causes of an unresponsive panel: wet fingers, the control lock, and sleep mode.
The market range
Dishwasher control-board work across South Florida sits in a researched market range of roughly $250 to $600 parts and labor. Ours starts at $265, and exact cost is confirmed after an on-site diagnostic.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about fisher & Paykel dishwasher control & motor repair cost
When would you tell me not to do this?
Two controllers gone on a machine past its first decade, or a controller plus a motor. At that point the total approaches what the drawer is worth, and you get told rather than quoted. It costs us the job and it is the correct outcome.
Can you repair the board rather than replace it?
No, and anybody offering to on a wet-environment appliance is taking a risk with your kitchen. These are replaced as assemblies. What we do instead is make sure the board is genuinely the cause before it is ordered.
The panel does not respond at all. Is that this repair?
Not until three free things are ruled out: water on your fingers, the control lock, and sleep mode. The maker publishes all three as the causes of unresponsive controls, and between them they end a good share of these calls in a minute.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name